The Soda Jerk Works
Thanks for visiting! If you own, restore, or service vintage soda machines, you are in the right place!
Be sure to check back often, since new features and products are added frequently!
CSS-64
DP115 SERVED IN CANS
SERVED IN CANS decal found on many machines from 1960 up. ...
DP118B LOADING INSTRUCTIONS
Bottle loading instructions for Cavalier square top ...
DP119B WIRING DIAGRAM
Cavalier wiring diagram for square top machines.
EP12A CAVALIER SQ TOP LAMP
Florescent lamp for marque in square top machines such as ...
EP13A Ballast
Ballast for fluorescent lamps in square corner machines of ...
EP14 Bulb
Bulb for sold out lens in Cavalier C-27 C-33 CS-64 CS-72 ...
EP15 Wiring Harness
Main wiring harness for most Vendo and Vendolator (except ...
EP15A Compressor Lead
Compressor lead for EP15 and EP16. This is used on all ...
EP15B Cavalier Stack Harness
Wiring harness from the stack to terminal block.
EP15C Cavalier Stack Harness
Wiring harness from stack to terminal block.
EP17 Thermostat Bracket
Thermostat bracket fits most machines.
For use on ...
EP19A Thermostat
Thermostat for most models. 9-3/4in capillary tube. ...
EP20 Solenoid
Bottle release solenoid for Cavalier, Vendo Vendolator ...
EP21 Coin Mechanism
Call to order. This is a rebuilt Coinco mechanism that ...
EP21A Slug Rejector
Slug Rejector AKA Coin Acceptor for Coinco units.
EP22 Micro Switch
Micro switch controlled by bottle solenoid for slant shelf ...
EP24 Start Capacitor
Start capacitor. This is a universal replacement for the ...
EP24A Heat Overload Relay
Heat overload relay for machines that have Tecumseh motors ...
EP50 DUCT SEAL
DUCT SEALANT. This seals the air gap where the service ...
EP9 Condenser Fan Bracket
Condenser fan motor bracket for most models mounts onto ...
HP101E Cavalier Script
Cavalier script for many square top machines. Goes near the ...